Automatic Filling And Sealing Machine can smoothly and accurately inject various materials like paste, cream, lotion show polish etc. viscosity fluid into the hose, and complete hot air heating, sealing and batch number, production date and so on. It is suitable for the filling and sealing of large-diameter plastic pipes and composite pipes in medicine, food, cosmetics, daily chemical products and other industries. It is an ideal and economical filling equipment for pharmaceutical, daily chemical and fine chemical industries.
1. Check that the components are intact and secure, that the power supply voltage is normal, and that the air circuit is normal of the tube filling machine.
2. Check that the sensor chain, cup holder, cam, switch, and color code are in good condition.
3. Check if the mechanical parts are linked and the lubrication is good.
4. Check whether the upper pipe station, the pressure pipe station, the light station, the filling station and the sealing station are coordinated.
5. Know the tools and other items around the device of the tube filling and sealing machine.
6. Check that the components of the feeder unit are intact and secure.
7. Check that the control switch is in the original position and use the hand-wheel to move the machine to determine if there is a fault.
8. After confirming that the previous process is normal, turn on the power supply and air valve, jog the machine for trial operation, run at low speed first, and gradually increase to normal operation speed after normal operation of the tube filling and sealing machine.
9. The upper pipe station adjusts the speed of the upper tube motor so that the electric pull rod speed matches the machine speed and keeps the automatic drop tube operation.
10. The pressure tube station drives the pressure head to operate at the same time by the up and down reciprocating motion of the cam linkage mechanism, and presses the hose to the correct position of the Tube Filling And Sealing Machine.
11. Use the hand-wheel to move to the light station for the light position, turn the light cam to make it work close to the light cam, and make the light beam of the photoelectric switch illuminate the center of the color mark, the distance is 5-10 mm.
12. The filling station is when the hose is lifted at the light station, the probe near the cone end of the tube is close to the switch and the signal is passed through the PLC and then operated by the solenoid valve, 20MM away from the end of the hose. When filling the paste is over.
13. Fill the amount of adjustment first loosen the nut, turn the respective screw and move the stroke arm slider position, increase outward, and vice versa, and finally lock the nut.
14. The sealing station adjusts the upper and lower positions of the sealing knife according to the needs of the pipe. The gap of the sealing knife is about 0.2MM of the Tube Filling And Sealing Machine.
15. Turn on the power and air supply, start the automatic running system, and fill the sealing machine into automatic operation.
16. It is strictly forbidden for non-maintenance operators to adjust each setting parameter arbitrarily. If the setting is incorrect, the unit may not work properly, and the unit may be damaged in severe cases. If there is indeed a need to adjust during the application, be sure to do so when the unit is stopped.
17. It is strictly forbidden to adjust the unit while the unit is running.
18. Stop press the “Stop” button, then turn off the power switch and air supply switch.
19. Completely clean the feeding unit and the filling and sealing machine unit.
20. Do a good job of equipment operation status record and routine maintenance record of the tube filling and sealing machine.